Professur Bauphysik
Refine
Document Type
- Article (23)
- Conference Proceeding (8)
- Bachelor Thesis (6)
- Master's Thesis (5)
- Doctoral Thesis (4)
- Preprint (3)
- Report (2)
- Study Thesis (2)
Institute
Keywords
- Bauphysik (10)
- Raumklima (8)
- Bauklimatik (5)
- computational fluid dynamics (5)
- Acoustic Travel-Time Tomography (4)
- Simulation (4)
- Strömungsmechanik (4)
- Akustische Laufzeit-Tomographie (3)
- BIM (3)
- Belüftung (3)
Overheating is a major problem in many modern buildings due to the utilization of lightweight constructions with low heat storing capacity. A possible answer to this problem is the emplacement of phase change materials (PCM), thereby increasing the thermal mass of a building. These materials change their state of aggregation within a defined temperature range. Useful PCM for buildings show a phase transition from solid to liquid and vice versa. The thermal mass of the materials is increased by the latent heat. A modified gypsum plaster and a salt mixture were chosen as two materials for the study of their impact on room temperature reduction. For realistic investigations, test rooms were erected where measurements were carried out under different conditions such as temporary air change, alternate internal heat gains or clouding. The experimental data was finally reproduced by dint of a mathematical model.
The human body is surrounded by a micro‐climate which results from its convective release of heat. In this study, the air temperature and flow velocity of this micro‐climate were measured in a climate chamber at various room temperatures, using a thermal manikin simulating the heat release of the human being. Different techniques (Particle Streak Tracking, thermography, anemometry, and thermistors) were used for measurement and visualization. The manikin surface temperature was adjusted to the particular indoor climate based on simulations with a thermoregulation model (UCBerkeley Thermal Comfort Model). We found that generally, the micro‐climate is thinner at the lower part of the torso, but expands going up. At the head, there is a relatively thick thermal layer, which results in an ascending plume above the head. However, the micro‐climate shape strongly depends not only on the body segment, but also on boundary conditions: the higher the temperature difference between the surface temperature of the manikin and the air temperature, the faster the air flow in the micro‐climate. Finally, convective heat transfer coefficients strongly increase with falling room temperature, while radiative heat transfer coefficients decrease. The type of body segment strongly influences the convective heat transfer coefficient, while only minimally influencing the radiative heat transfer coefficient.
Occupant needs with regard to residential buildings are not well known due to a lack of representative scientific studies. To improve the lack of data, a large scale study was carried out using a Post Occupancy Evaluation of 1,416 building occupants. Several criteria describing the needs of occupants were evaluated with regard to their subjective level of relevance. Additionally, we investigated the degree to which deficiencies subjectively exist, and the degree to which occupants were able to accept them. From the data obtained, a hierarchy of criteria was created. It was found that building occupants ranked the physiological needs of air quality and thermal comfort the highest. Health hazards such as mould and contaminated building materials were unacceptable for occupants, while other deficiencies were more likely to be tolerated. Occupant satisfaction was also investigated. We found that most occupants can be classified as satisfied, although some differences do exist between different populations. To explain the relationship between the constructs of what we call relevance, acceptance, deficiency and satisfaction, we then created an explanatory model. Using correlation and regression analysis, the validity of the model was then confirmed by applying the collected data. The results of the study are both relevant in shaping further research and in providing guidance on how to maximize tenant satisfaction in real estate management.
Patients and staff in hospitals are exposed to a complex sound environment with rather high noise levels. In intensive care units, the main noise sources are hospital staff on duty and medical equipment, which generates both operating noise and acoustic alarms. Although noise in most cases is produced during activities for the purpose of saving life, noise can induce significant changes in the depth and quality of sleep and negatively affect health in general. Results of a survey of hospital staff are presented as well as measurements in two German hospital wards: a standard two-bed room and a special Intermediate Care Unit (IMC-Unit), each in a different Intensive Care Unit (ICU). Sound pressure data were collected over a 48 hour period and converted into different levels (LAFeq, LAFmax, LAFmin, LAF 5%), as well as a rating level LAr, which is used to take tonality and impulsiveness into account. An analysis of the survey and the measured data, together with a comparison of thresholds of national and international regulations and standards describe the acoustic situation and its likely noise effects on staff and patients.
Summer overheating in buildings is a common problem, especially in office buildings with large glazed facades, high internal loads and low thermal mass. Phase change materials (PCM) that undergo a phase transition in the temperature range of thermal comfort can add thermal mass without increasing the structural load of the building. The investigated PCM were micro-encapsulated and mixed into gypsum plaster. The experiments showed a reduction of indoor-temperature of up to 4 K when using a 3 cm layer of PCM-plaster with micro-encapsulated paraffin. The measurement results could validate a numerical model that is based on a temperature dependent function for heat capacity. Thermal building simulation showed that a 3 cm layer of PCM-plaster can help to fulfil German regulations concerning heat protection of buildings in summer for most office rooms.
Forscher prognostizieren in den kommenden Jahren eine Klimaerwärmung bis zu 6 ° C. Aus diesem Grund wurde das EU – Forschungsprojekt „ Climate for Culture“ ins Leben gerufen, um Auswirkungen dieses Klimawandels auf denkmalgeschützte, kulturhistorische Gebäude zu untersuchen. Ziel ist es, entsprechende Schutzmaßnahmen in konservatorischer Hinsicht zu erarbeiten.
Aufgrund des Zusammenhanges zwischen Temperatur und Luftfeuchte führt diese Klimaerwärmung auch zu einer Änderung des Feuchtehaushaltes im Außenbereich und, bedingt durch einen immer vorhandenen Luftwechsel, schließlich auch im Innenbereich von Gebäuden.
Die Fähigkeit eines Gebäudes, durch seine Beschaffenheit auf Feuchteeinflüsse zu reagieren, wird maßgeblich bestimmt durch seine Möglichkeit, in der Gebäudehülle und der vorhandenen Einrichtung anfallende Feuchte zwischenzuspeichern und diese zeitversetzt wieder an die Umgebung abzugeben. Diese Fähigkeit sorptiver Flächen zur Feuchtepufferung konnte bislang nur mit erheblichem Aufwand ermittelt werden.
In der vorliegenden Arbeit wird versucht, durch einfachere Methoden mittels hygrothermischer Simulation einen „Zweizahlwert“ zu erhalten, mit dem sich diese Raumkompetenz schnell und nachvollziehbar darstellen lässt.
Nutzerorientierte Bausanierung bedeutet eine gegenüber dem konventionellen Vorgehen deutlich verstärkte Ausrichtung des Planungs- und Sanierungsprozesses auf die Anforderungen und Bedürfnisse des zukünftigen Nutzers eines Gebäudes. Dies hat einerseits ein hochwertigeres Produkt zum Ergebnis, erfordert andererseits aber auch den Einsatz neuer Methoden und Baustoffe sowie ein vernetztes Zusammenarbeiten aller am Bauprozess Beteiligten. Der Fokus der Publikation liegt dabei auf den Bereichen, die eine hohe Relevanz für die nutzerorientierte Bausanierung aufweisen. Dabei handelt es sich insbesondere um: Computergestütztes Bauaufmaß und digitale Bauwerksmodellierung (BIM), bauphysikalische Methoden zur Optimierung von Energieeffizienz und Behaglichkeit bei der Sanierung von Bestandsgebäuden, zerstörungsfreie Untersuchungsmethoden im Rahmen einer substanzschonenden Bauzustandsanalyse und Entwicklung von Ergänzungsbaustoffen.
Das Projekt nuBau ist eine Kooperation zwischen den Fakultäten Bauingenieurwesen und Architektur der Bauhaus-Universität Weimar. Die beteiligten Professuren sind: Bauphysik, Informatik in der Architektur, Polymere Werkstoffe und Werkstoffe des Bauens.
Bauphysikalisches Quartett
(2012)
Quartett ist ein ebenso altes, wie auch beliebtes Kartenspiel. Vor allem bei Kindern erfreut es sich großer Beliebtheit, während in den älteren Generationen kaum jemand mit Quartettkarten spielt.
Quartettspiele speziell für Kleinkinder sind zum Großteil mit Inhalten versehen, die Wissen auf spielerische Art und Weise vermitteln. Dabei werden gute Lernerfolge in dieser Zielgruppe verzeichnet.
Wie lassen sich also diese Lernerfolge durch das Spielen mit Quartettkarten erzielen? Und wie kann dieser Effekt auch auf Studenten übertragen werden?
Ziel dieser Arbeit ist es, das Konzept des Quartettkartenspiels auf bauphysikalische Inhalte anzuwenden und gegebenenfalls die Spielprinzipien zu erweitern oder zu verändern. Dabei sind die Studenten der Fakultät Bauingenieurswesen die Zielgruppe, an die sich das Spiel richten soll.
Besondere Herausforderung ist es, unterschiedliche Objekteklassen von bauphysikalischer Relevanz in einem Spiel zusammenzubringen und vergleichbar zu machen. Das sich ergebende Quartettkartenspiel sollte nicht nur eine Objektklasse, sondern mehrere Objektklassen zum Inhalt haben. Dabei sollen die Objektklassen so gewählt werden, dass sich Kategorien mit bauphysikalischem Inhalt finden lassen.
Augenmerk sollte auch auf die Strukturierung der Lerninhalte gelegt werden, um eine leichte Übertragung des Spielkonzepts auf andere Fachdomänen zu ermöglichen. Das Ergebnis der Arbeit sind zwei fertige und spielbare Quartette.
Capturing Sheep With Minecraft befasst sich mit ausgewählten Problemen der Bauphysik und deren Umsetzung mithilfe des Computerspiels Minecraft. Es werden ausgewählte Probleme der Bauphysik in Minecraft abgebildet um diese Schülern und Studenten näher zu bringen. Es wurde ein Szenario in Minecraft entworfen welches durch entgegenwirken der abgebildeten Probleme, durch den Spieler gelöst werden soll.