51.75 Verbundwerkstoffe, Schichtstoffe
Refine
Document Type
- Article (1)
- Doctoral Thesis (1)
Institute
Keywords
- CFRP (1)
- Holzbau (1)
- Kohlenstoff (1)
- Kohlenstofffaserverstärkter Kunststoff (1)
- Nanowissenschaften (1)
- Sanierung (1)
- Verbund (1)
- Verbundwerkstoff (1)
- Vorspannung (1)
- composite (1)
Year of publication
- 2015 (2) (remove)
The Carbon journal is pleased to introduce a themed collection of recent articles in the area of computational carbon nanoscience. This virtual special issue was assembled from previously published Carbon articles by Guest Editors Quan Wang and Behrouz Arash, and can be accessed as a set in the special issue section of the journal website homepage: www.journals.elsevier.com/carbon. The article below by our guest editors serves as an introduction to this virtual special issue, and also a commentary on the growing role of computation as a tool to understand the synthesis and properties of carbon nanoforms and their behavior in composite materials.
The refurbishment of old buildings often goes hand in hand with an increase in both the dead and live loads. The latter, combined with the higher safety factors, often make the reinforcement of the old structures necessary. Most reinforcement methods involve transforming a structural timber member into a composite beam. Composite sections have a long tradition in timber construction. In the early days, multiple timber beams were connected with interlocking tooth and wooden shear connecters, which resulted in an elastic connection. Although historical timber structures are frequently upgraded, no method has yet been established and fully accepted by all stakeholders such as owners, builders, architects, engineers and cultural heritage organisations. Carbon fibre-reinforced polymers (CFRP) have already shown their efficiency in structural reinforcement especially in concrete structures. Moreover, previous studies have shown that CFRP has the potential to meet the expectations of all parties involved.
In order to reach the service-limit state, a high amount of carbon fibres has to be used, or considering the cost of reinforcement, prestress has to be applied. However, prestressing often goes hand-in-hand with delaminating issues. The camber method presented here offers an efficient solution for prestressing timber bending members and overcoming the known obstacles.
In the method proposed, the timber beam is cambered using an adjustable prop at midspan during the bonding of the CRFP-lamella to the lower side of the bending member. After curing the adhesive, the prop is removed and the prestressed composite beam is ready to be used. The prestress introduced in the system is not constant, but has a triangular shape and peaks at midspan, where it is used the most. The prestress force, which declines towards the end of the beam, leads to a constant shear stress over the whole length of the reinforcement,avoiding a concentrated anchorage zone.
An analytical calculation model has been developed to calculate and design prestressed timber-
bending members using the camber method. Numerical modelling, using a multi-surface plasticity model for timber, confirmed the results from the analytical model, and clearly reduced delaminating issues, comparing very favourably to traditional prestressing methods. The experimental parametric study, including the determination of the short-term loadbearing capacity of structural-sized beams, showed agreement with the analytical and numerical calculation. The prestressed reinforcement showed a benefit of nearly 50% towards the ultimate-limit state and up to 70% towards the service-limit state. Calculations revealed that the use of high modulus CFRP allows even higher benefits, depending on the configurations and requirements. The long-term design of the prestressed composite beam was investigated by extending the analytical model. The creep of the timber leads to a load transfer from the timber towards the CFRP, and therefore increases the benefit towards the ultimatelimit design. Applying high modulus CFRP-lamellas allows for a complete utilisation of the
design capacity of timber and carbon fibre-reinforced polymer.
The thorough investigation conducted demonstrated that the camber method is an efficient technique for prestressing and reinforcing timber-bending members. Furthermore, the calculation model presented allows for a safe design and estimation of long-term behaviour.