Refine
Document Type
- Article (6)
- Conference Proceeding (4)
- Doctoral Thesis (1)
Institute
- Professur Stahlbau (3)
- Graduiertenkolleg 1462 (2)
- In Zusammenarbeit mit der Bauhaus-Universität Weimar (2)
- Institut für Strukturmechanik (ISM) (2)
- Juniorprofessur Simulation und Experiment (1)
- Professur Angewandte Mathematik (1)
- Professur Bauchemie und Polymere Werkstoffe (1)
- Professur Stochastik und Optimierung (1)
Keywords
- Angewandte Mathematik (4)
- Computerunterstütztes Verfahren (4)
- Quarzglas (3)
- Angewandte Informatik (2)
- Architektur <Informatik> (2)
- Berührungslose Messung (2)
- CAD (2)
- Laser (2)
- Laserschweißen (2)
- Polieren (2)
- Strukturmechanik (2)
- Affecting factors; Measurement uncertainty; Materials testing; Quantitative comparison; Strain comparison; Tensile test (1)
- Baustahl (1)
- Building Information Modeling (1)
- Data, information and knowledge modeling in civil engineering; Function theoretic methods and PDE in engineering sciences; Mathematical methods for (robotics and) computer vision; Numerical modeling in engineering; Optimization in engineering applications (1)
- Edelstahl (1)
- Eigenspannung (1)
- Empfindlichkeit (1)
- Feinkornbaustahl (1)
- Ferri (1)
- Laser Welding; CO2; Diode; Distortion; Finite Element Analysis; Thermal Analysis; Mechanical Analysis; Numerical Model (1)
- Laser; quartz glass; polishing; temperature; residual stress; simulation; contactless measurement (1)
- MAG-Schweißen (1)
- Schweißen (1)
- Schweißverbindung (1)
- Simulation (1)
- Stochastik (1)
- Temperatur (1)
- Werkstoffprüfung (1)
- Wärmeeinflusszone (1)
- Zugversuch (1)
- joints (1)
- laser; contactless measurement; quartz glass; polishing; temperature; residual stress; simulation; sensitivity (1)
- numerical simulation (1)
- residual stress (1)
- steel (1)
- welding (1)
A known phenomenon during laser welding of thin sheets is the deformation caused by thermally induced stresses. This deformation can result in a change of the gap width between the welded parts, which leads to an unstable welding process. Inducing displacements by using a second heat source will compensate for the change in gap width, hence optimizing the welding process. The base material is 1 mm thick austenitic stainless steel 1.4301, which is welded by a CO2 laser. The second heat source is a diode laser. The gap between the welded parts was set between 0.05 mm and 0.1 mm. The influence of the second heat source on the welding process and the welding result is described. The usage of a second heat source allows a higher gap width to be set prior to the welding process. The results of the numerical simulation were found to be corresponding to those of the experiments.