TY - JOUR A1 - Cappachione, Clotilde A1 - Partschefeld, Stephan A1 - Osburg, Andrea A1 - Gliubizzi, Rocco A1 - Gaeta, Carmine T1 - Modified Carboxymethylcellulose-Based Scaffolds as New Potential Ecofriendly Superplasticizers with a Retardant Effect for Mortar: From the Synthesis to the Application JF - Materials N2 - This article is focused on the research and development of new cellulose ether derivatives as innovative superplasticizers for mortar systems. Several synthetic strategies have been pursued to obtain new compounds to study their properties on cementitious systems as new bio-based additives. The new water-soluble admixtures were synthesized using a complex carboxymethylcellulose-based backbone that was first hydrolyzed and then sulfo-ethylated in the presence of sodium vinyl sulphonate. Starting with a complex biopolymer that is widely known as a thickening agent was very challenging. Only by varying the hydrolysis times and temperatures of the reactions was achieved the aimed goal. The obtained derivatives showed different molecular weight (Mw) and anionic charges on their backbones. An improvement in shear stress and dynamic viscosity values of CEM II 42.5R cement was observed with the samples obtained with a longer time of higher temperature hydrolysis and sulfo-ethylation. Investigations into the chemical nature of the pore solution, calorimetric studies and adsorption experiments clearly showed the ability of carboxymethyl cellulose superplasticizer (CMC SP) to interact with cement grains and influence hydration processes within a 48-h time window, causing a delay in hydration reactions in the samples. The fluidity of the cementitious matrices was ascertained through slump test and preliminary studies of mechanical and flexural strength of the hardened mortar formulated with the new ecological additives yielded values in terms of mechanical properties. Finally, the computed tomography (CT) images completed the investigation of the pore network structure of hardened specimens, highlighting their promising structure porosity. KW - Mörtel KW - Verflüssigung KW - superplasticizers KW - carboxymethylcellulose KW - mortar KW - OA-Publikationsfonds2021 Y1 - 2021 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:gbv:wim2-20210804-44689 UR - https://www.mdpi.com/1996-1944/14/13/3569 VL - 2021 IS - volume 14, issue 13, article 3569 SP - 1 EP - 17 PB - MDPI CY - Basel ER - TY - THES A1 - Göbel, Luise T1 - Experimental and semi-analytical multiscale approaches for the characterization of the elastic and viscoelastic behavior of polymer-modified cement-based materials T1 - Experimentelle und semi-analytische Multiskalenmethoden für die Charakterisierung des elastischen und viskoelastischen Verhaltens polymermodifizierter zementgebundener Materialien N2 - Polymer-modified cement concrete (PCC) is a heterogeneous building material with a hierarchically organized microstructure. Therefore, continuum micromechanics-based multiscale models represent a promising method to estimate the mechanical properties. By means of a bottom-up approach, homogenized properties at the macroscopic scale are derived considering microstructural characteristics. The extension of existing multiscale models for the application to PCC is the main objective of this work. For that, cross-scale experimental studies are required. Both macroscopic and microscopic mechanical tests are performed to characterize the elastic and viscoelastic properties of different PCC. The comparison between experiment and model prediction illustrates the success of the modeling approach. N2 - Polymermodifizierter Beton (PCC) ist ein heterogener Baustoff mit einer hierarchisch organisierten Mikrostruktur. Deshalb sind Multiskalenmodelle, die auf Prinzipien der Kontinuumsmikromechanik beruhen, sehr gut für die Abschätzung mechanischer Eigenschaften geeignet. Mit Hilfe eines Bottom-Up-Ansatzes werden unter Berücksichtigung mikrostruktureller Charakteristika homogenisierte Eigenschaften auf der makroskopischen Materialebene erhalten. Die Erweiterung bestehender Multiskalenmodelle für die Anwendung auf PCC ist das Hauptziel dieser Arbeit. Dafür werden skalenübergreifende Experimente herangezogen. Sowohl makroskopische als auch mikroskopische mechanische Tests werden durchgeführt, um das elastische und viskoelastische Verhalten verschiedener PCC zu charakterisieren. Ein Vergleich zwischen experimentellen Ergebnissen und der entsprechenden Modellvorhersage verdeutlicht den Erfolg des Modellierungsansatzes. T3 - Schriftenreihe des DFG Graduiertenkollegs 1462 Modellqualitäten // Graduiertenkolleg Modellqualitäten - 19 KW - Elastizitätsmodul KW - Zementstein KW - Kunststoffadditiv KW - Modellierung KW - Mehrphasensystem KW - Multiskalenmodellierung KW - Multiscale modeling KW - Mikrostruktur KW - Polymermodifizierung KW - Kriechen KW - Elastizitätsmodul KW - Microstructure KW - Polymer modification KW - Creep KW - Young's modulus Y1 - 2018 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:gbv:wim2-20181211-38279 SN - 978-3-95773-269-9 PB - Bauhaus-Universitätsverlag CY - Weimar ER - TY - THES A1 - Kirsten, Heike T1 - Herkunft, Eigenschaften und Konservierungsmöglichkeiten von Lettenkeuper- und Schilfsandsteinen an Baudenkmalen in Thüringen T1 - Occurrences, parameters and damage appearances of the Lower and Middle Keuper sandstones on historic buildings in Thuringia N2 - Lettenkeuper- und Schilfsandsteine sind in Thüringen weit verbreitet und wurden häufig als Werk- und Bildhauersandsteine verwendet. Die überwiegend tonig-ferritisch gebundenen Steine sind stark witterungsanfällig. Inzwischen droht ein unwiederbringlicher Substanzverlust an vielen denkmalpflegerisch wertvollen Gebäuden und an plastischen Bildwerken. Die Dissertation gibt einen Überblick über die Vorkommen, Eigenschaften und Schadbilder dieser Sandsteine in Thüringen. Konservierungsmaßnahmen, die in Thüringen in den vergangenen 20 Jahren an Lettenkeuper- und Schilfsandsteinen vorgenommen wurden, werden ausgewertet und neue Erkenntnisse zur Konservierung dieser Sandsteine vorgestellt. N2 - Sandstones of the Lower and Middle Keuper are widely spread in Thuringia. They were often used as building stones or as material for exposed masonry as well as for sculptures. Lower and Middle Keuper sandstones contain a high percentage of cements and are therefore very susceptible to weathering damages. Many valuable historic buildings and plastics are facing an irrecoverable stone erosion. This thesis provides an overview of the occurrences, the parameters and damage appearances of the Lower and Middle Keuper sandstone in Thuringia. Previous conservation strategies will be described and their results analysed. KW - Konservierung KW - Restaurierung KW - Denkmalpflege KW - Naturstein KW - Baustein KW - Steinkonservierung KW - Steinfestigung KW - Lettenkeupersandstein KW - Schilfsandstein KW - natural building stone KW - stone decay KW - stone consolidation KW - Lower Keuper Sandstone KW - Middle Keuper Sandstone Y1 - 2009 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:gbv:wim2-20091116-14900 ER - TY - THES A1 - Schirmer, Ulrike T1 - Die Adsorption von Dispersionspartikeln und Schutzkolloiden an Oberflächen von Zementphasen und Phasen der Zusatzstoffe N2 - Ziel der Arbeit war das Adsorptionsverhalten ausgewählter schutzkolloidstabilisierter Polymerpartikel mit variierender chemischer Basis im zementären System zu beschreiben und basierend auf den gewonnenen Erkenntnissen das Konkurrenzverhalten beim Angebot unterschiedlicher mineralischer Oberflächen zu klären. Sowohl die Destabilisierung der Polymerpartikel im alkalischen Milieu, welche eine Voraussetzung für derartige Adsorptionsprozesse ist, als auch die Veränderung von Oberflächeneigenschaften verschiedener mineralischer Partikel durch Hydratations- und Ionenadsorptionsprozesse, wurden u. a. mit Hilfe elektrokinetischer Experimente erfasst. Die spektralphotometrische Erstellung von Adsorptionsisothermen ermöglichte zudem die Ermittlung der jeweiligen adsorbierten Polymermenge zu verschiedenen Zeitpunkten der frühen Hydratation. Weiterhin wurde die Polymeradsorption an Partikeln ausgewählter Zusatzstoffe in Abhängigkeit von der Ionenstärke der Flüssigphase beschrieben. Rasterelektronenmikroskopische Untersuchungen cryo-präparierter polymermodifizierter Zementleimproben ermöglichten es außerdem deren Mikrostruktur im suspensiven Zustand zu visualisieren. Diese Aufnahmen, ebenso wie die Ergebnisse grundlegender hydratationskinetischer Untersuchungen wurden in Wechselbeziehung zu den Ergebnissen der Adsorptionsuntersuchungen gebracht. Maßgelbliche intermolekulare und interpartikuläre Wechselwirkungen, infolge derer sich die Stabilitätsverhältnisse im Zementleim ändern und die Polymerpartikel adsorbieren sind im Wesentlichen die Desorption des Schutzkolloids von der Polymerpartikeloberfläche, die Ionisation funktioneller Gruppen der Polymerpartikel und der Schutzkolloidmakromoleküle im alkalischen Milieu und infolgedessen die Komplexbildung mit Ionen der Zementleimporenlösung. Die Auswirkungen dieser Vorgänge auf die Lösungs- und Fällungskinetik des Zementleimes wurden erfasst und mit der chemischen Zusammensetzung der polymeren Systeme korreliert. KW - Kunststoffmörtel KW - Interpartikuläre Wechselwirkungen KW - Suspensionsanalytik KW - Lösungsanalytik KW - Mikroskopie KW - Polymeradsorption KW - Kunststoffadditiv KW - Mikrostruktur KW - Mehrphasensystem Y1 - 2018 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:gbv:wim2-20180327-37383 ER - TY - JOUR A1 - Wiegand, Torben A1 - Osburg, Andrea T1 - Synthesis, Curing and Thermal Behavior of Amine Hardeners from Potentially Renewable Sources JF - Polymers N2 - Research into bio-based epoxy resins has intensified in recent decades. Here, it is of great importance to use raw materials whose use does not compete with food production. In addition, the performance of the newly developed materials should be comparable to that of conventional products. Possible starting materials are lignin degradation products, such as vanillin and syringaldehyde, for which new synthesis routes to the desired products must be found and their properties determined. In this article, the first synthesis of two amine hardeners, starting with vanillin and syringaldehyde, using the Smiles rearrangement reaction is reported. The amine hardeners were mixed with bisphenol A diglycidyl ether, and the curing was compared to isophorone diamine, 4-4′-diaminodiphenyl sulfone, and 4-Aminonbenzylamine by means of differential scanning calorimetry. It was found that the two amines prepared are cold-curing. As TG-MS studies showed, the thermal stability of at least one of the polymers prepared with the potentially bio-based amines is comparable to that of the polymer prepared with isophorone diamine, and similar degradation products are formed during pyrolysis. KW - Epoxide KW - Epoxidharz KW - Polymere KW - epoxy KW - amine hardener KW - curing agent KW - bio-based KW - vanillin KW - OA-Publikationsfonds2023 Y1 - 2023 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:gbv:wim2-20230524-63745 UR - https://www.mdpi.com/2073-4360/15/4/990 VL - 2023 IS - volume 15, issue 4, article 990 SP - 1 EP - 12 PB - MDPI CY - Basel ER -