@article{AnsariTartaglioneKoenke,
  author    = {Ansari, Meisam and Tartaglione, Fabiola and K{\"o}nke, Carsten},
  title     = {Experimental Validation of Dynamic Response of Small-Scale Metaconcrete Beams at Resonance Vibration},
  series = {materials},
  volume    = {2023},
  journal   = {materials},
  number    = {volume 16, issue 14, article 5029},
  publisher = {MDPI},
  address   = {Basel},
  doi       = {10.3390/ma16145029},
  url       = {http://nbn-resolving.de/urn:nbn:de:gbv:wim2-20230818-64154},
  pages     = {1 -- 17},
  abstract  = {Structures and their components experience substantially large vibration amplitudes at resonance, which can cause their failure. The scope of this study is the utilization of silicone-coated steel balls in concrete as damping aggregates to suppress the resonance vibration. The heavy steel cores oscillate with a frequency close to the resonance frequency of the structure. Due to the phase difference between the vibrations of the cores and the structure, the cores counteract the vibration of the structure. The core-coating inclusions are randomly distributed in concrete similar to standard aggregates. This mixture is referred to as metaconcrete. The main goal of this work is to validate the ability of the inclusions to suppress mechanical vibration through laboratory experiments. For this purpose, two small-scale metaconcrete beams were cast and tested. In a free vibration test, the metaconcrete beams exhibited a larger damping ratio compared to a similar beam cast from conventional concrete. The vibration amplitudes of the metaconcrete beams at resonance were measured with a frequency sweep test. In comparison with the conventional concrete beam, both metaconcrete beams demonstrated smaller vibration amplitudes. Both experiments verified an improvement in the dynamic response of the metaconcrete beams at resonance vibration.},
  subject      = {Beton},
  language  = {en}
}
@unpublished{RadmardRahmaniKoenke,
  author    = {Radmard Rahmani, Hamid and K{\"o}nke, Carsten},
  title     = {Passive Control of Tall Buildings Using Distributed Multiple Tuned Mass Dampers},
  doi       = {10.25643/bauhaus-universitaet.3859},
  url       = {http://nbn-resolving.de/urn:nbn:de:gbv:wim2-20190311-38597},
  pages     = {43},
  abstract  = {The vibration control of the tall building during earthquake excitations is a challenging task due to their complex seismic behavior. This paper investigates the optimum placement and properties of the Tuned Mass Dampers (TMDs) in tall buildings, which are employed to control the vibrations during earthquakes. An algorithm was developed to spend a limited mass either in a single TMD or in multiple TMDs and distribute them optimally over the height of the building. The Non-dominated Sorting Genetic Algorithm (NSGA - II) method was improved by adding multi-variant genetic operators and utilized to simultaneously study the optimum design parameters of the TMDs and the optimum placement. The results showed that under earthquake excitations with noticeable amplitude in higher modes, distributing TMDs over the height of the building is more effective in mitigating the vibrations compared to the use of a single TMD system. From the optimization, it was observed that the locations of the TMDs were related to the stories corresponding to the maximum modal displacements in the lower modes and the stories corresponding to the maximum modal displacements in the modes which were highly activated by the earthquake excitations. It was also noted that the frequency content of the earthquake has significant influence on the optimum location of the TMDs.},
  subject      = {Schwingungsd{\"a}mpfer},
  language  = {en}
}